HOW TO CONFIGURE PASSBOOK PRINTER TO WORK THROUGH USB CABLE?

 Procedure To Configure PB Printer To Work Through USB Cable

HOLD BOTH STATION1 and STATION2 BUTTONS IN THE PRINTER

• Switch on the printer
• Leave the Buttons
• Insert the paper into the printer
• Automatically Printer will take the paper inside and a message will be printed as follows

STATION 1-CONFIRM STATION 2=SKIP PRESS LOCAL TO CONTINUE

• Press LOCAL and then STATION 1
• The Default Configuration will be printed as follows

MENU : CONFIG Press STATION 1 DRAFT SPEED: NORMAL Press STATION 1 LQ TYPE: NLQ1 Press STATION 1
PAPER WIDTH: FIRST LINE Press STATION 1
BUZZER: Y Press STATION 1
INTERFACE By default SERIAL or COM1 will be there Press STATION2
Till USB is printed and then Press STATION 1
USB EMULATION By default OLIVETTI will be there Press STATION2
Till IBM is printed and then Press STATION 1
PLUG&PLAY: N Press STATION 1
PAP.EDGE DECTEC.: N Press STATION 1
SPECIAL FORMS: N Press STATION 1
PRINT MODE STANDARD Press STATION 1
BIM MODE: MONO Press STATION 1
PNS SELECTIONS: N Press STATION 1
SAVE PARAMETERS Y Press STATION 1
MENU : CONFIG

• Leave the paper in the printer and switch off the printer (Press power button in the PB printer)
• SWITCH ON THE PRINTER 
• Automatically the paper will be ejected
• THE SAME METHOD MAY BE USED TO CONFIGURE SERIAL OR COM1 PORT

Calibrate Passbook printer to Clean the Sensors

Share on Google Plus

About SPOs Karimnagar

J. PANDARI, SUPDT OF POST OFFICES, KARIMNAGAR DIVISION, KARIMNAGAR - 505 001 JOINED ON 23-05-2016.